Two Notes VM-202 - Manual (Page 23)

Part 4
Configuring and using the Torpedo
VM-202
1 The VM-202 interface
The VM-202 parameters are organized in menus, accessible by different switches and knobs.
Three kinds of controllers are provided :
• four rotary encoders : input gain, output volume, navigation (NAVI).
• eleven switches : menus SETUP, PROGRAM, COMPARE, SPKR/MIC, MIKING, POST FX, two BYPASS,
CHANNEL EDIT, OK, ESC.
• one potentiometer : controls the headphone output volume.
Every action is displayed on the main screen of the unit (number 4 in figure 2. 2.2) or on the LEDs near
the knob (CHANNEL EDIT, COMPARE or BYPASS). You can also check that what you do has an impact on
the unit. The two-digit display (number 3 in figure 2. 2.2) lets you know the current preset number.
6 7 5 4
3
2
1
Figure 4.1: VM-202 idle screen
1 Preset Name 3 Channel B 5 Output Sampling Frequency 7 USB Sync
2 Channel A 4 Digital Sync 6 MIDI signal
In the following paragraphs, we will illustrate all the commands and menus available from the left to
the right of the unit by indicating the corresponding figure 2. 2.2.
Two Notes Audio Engineering Torpedo VM-202 23