Programming modes, Auto increment mode – Turning Technologies ResponseCard Programmer User Manual
Page 6
ResponseCard Programmer
6
PROGRAMMING MODES
The ResponseCard Programmer has three programming modes:
Auto Increment Mode
Auto Increment Mode allows users to set a starting Unit ID. In this mode, the Unit ID increases by one after each
ResponseCard is programmed. This mode simplifies sequential programming.
1
Press Menu/OK to return to the Main Screen.
2
Use the down arrow to highlight Mode.
3
Press Menu/OK.
4
Highlight Auto Increment and press Menu/OK.
5
Highlight Program and select Menu/OK.
The following screen appears:
6
If necessary, use the up and down arrows to change the Unit ID. Press Menu/OK.
The following screen appears:
turningtechnologies.com/user-guides