Turning Technologies ResponseCard Programmer - Manual (Page 5)

ResponseCard Programmer 5
Changing the ResponseCard Programmer Channel
The ResponseCard Programmer channel must be set to the same channel as the ResponseCards.
1 Press Menu/OK to return to the Main Screen.
2 Use the down arrow to highlight Channel.
3 Press Menu/OK.
4 Use the up and down arrows to change the channel.
5 Press Menu/OK to set the channel.
NOTE
It is not necessary to plug in a receiver to program ResponseCards.
Setting the Program Key
The ResponseCard Programmer uses a program key to program all ResponseCards to their new Unit ID. The Program Key
(0/J - 9/I on the ResponseCards) is the key that will be used to program the ResponseCards. It should be a key that is
uncommonly used in the surrounding environment. 9/I is the default Program Key.
1 Press Menu/OK to return to the Main Screen.
2 Use the down arrow to highlight Setup.
3 Press Menu/OK.
4 Highlight Program Key and press Menu/OK.
5 Use the up and down arrows to highlight a Program Key.
6 Press Menu/OK to set the Program Key.
Setting the Screen Contrast
The screen contrast on the ResponseCard Programmer can be adjusted.
1 Press Menu/OK to return to the Main Screen.
2 Use the down arrow to highlight Setup.
3 Press Menu/OK.
4 Use the down arrow to highlight Contrast.
5 Press Menu/OK.
6 Use the left and right arrows to adjust the contrast.
7 Press Menu/OK to set the contrast.
turningtechnologies.com/user-guides