StorCase Technology DS400 - Manual (Page 20)

Installation 11
DS400 User's Guide - Rev. E01 StorCase Technology, Inc.
Figure 10: Installing the Drive
Note: The DS400 is equipped with a removable drive bay partition located on the front
panel of the DS400 (Figure 2). This partition may be removed so that drives can
be spaced apart for increased chassis ventilation.
3. Attach the drive activity and drive fault indicator LED cables to the appropriate drive
pins (efer to the device manufacturer's documentation for the location of these pins).
4. Install the drive(s) into the drive mounting bracket using four (4) #6-32 Phillips screws
(Figure 10). Be careful not to pinch or crimp attached cables. Do not fully tighten
the screws at this point.