StorCase Technology DS350 - Manual (Page 16)

DS350 User's Guide - Rev. A00 Kingston Technology Company
Installation 7
Drive Preparation
1. Remove the drive from its protective packaging.
2. SCSI Drive Termination - The last drive on any SCSI channel must have termination
enabled. In most instances, depending upon cable configuration, termination will be
handled by an external terminator on the DS350 back panel. If using an external
terminator, disable onboard termination. Refer to the documentation provided by the
drive manufacturer for the location of these terminators or jumpers. External active
termination is recommended for best SCSI performance (terminator not included with
the DS350).
Removing the Drive Bracket
NOTE: Removal of the access panel (Figure 5) and drive bracket (Figure 6) is required
in order to install the drive(s). Once the drive(s) are installed into the bracket,
the entire drive/bracket assembly can then be installed into the chassis.
1. Remove the access panel (Figure 5).
2. Remove the two (2) screws securing the drive bracket to the chassis (Figure 6).
3. Remove the drive bracket from the chassis by carefully lifting the rear of the
bracket and sliding it toward the chassis back panel (Figure 6).
Figure 6: Removing the Drive Bracket