StorCase Technology DS100 - Manual (Page 19)

10 Installation
StorCase Technology, Inc. DS100 User's Guide - Rev. F02
Use Flat Blade
Screwdriver to
Remove Filler Panel
0535
Figure 9: Removing the Filler Panel
Drive Installation
The process of installing a drive into the DS100 chassis varies slightly, depending upon the
model. DS100 1-bay and 2-bay models require the removal of the drive mounting bracket to
access drive mounting screws. The DS100 4-bay does not require the removal of the drive
mounting bracket.
IF INSTALLING A DRIVE INTO THE DS100 1-BAY OR DS100 2-BAY:
1. Turn the DS100 over and place it on a soft clean surface, so that the bottom is facing
upward.
2. Loosen but do not remove the four (4) screws that secure the drive mounting bracket
to the DS100 chassis (Figure 10).
3. Place the DS100 in an upright position so that it rests on its four rubber feet.
4. Remove the drive mounting bracket from the chassis by sliding it toward the chassis
back panel, then lifting upward.
6. If installing removable media devices, remove the appropriate filler panels from the
DS100. These panels can easily be removed by applying a small amount of pressure
with the tip of a screwdriver to the filler panel clips, which are visible in the cutouts
on the drive mounting bracket (Figure 9). If installing fixed media device(s), leave the
filler panel(s) in place.