StorCase Technology DE300i-SW160 - Manual (Page 22)

DE300i-SW160 User's Guide - Rev. A00 StorCase Technology Inc.
Installation 15
Adjusting the Spin Down/Up Timer
NOTE: The timer for device spin down is controlled by a small selector,
located in a cutout on the side of the DE300i-SW160 receiving frame
as shown in Figure 10. The amount of time required for a drive to spin
down is approximately 15 seconds or more. This number can vary
depending on the type of SCSI device and manufacturer (some drives
may require 45 seconds or more). The factory configuration is set for
20 seconds. A different delay time may be selected with the provided
alignment tool. Refer to the SCSI device manufacturer’s manual for
more information on required device spin down time.
Front of
Receiving
Frame
0445
0
2
4
6
8
A
C
E
0 = 10 SECONDS 8 = 50 SECONDS
1 = 15 SECONDS 9 = 55 SECONDS
2 = 20 SECONDS A = 60 SECONDS
3 = 25 SECONDS B = 65 SECONDS
4 = 30 SECONDS C = 70 SECONDS
5 = 35 SECONDS D = 75 SECONDS
6 = 40 SECONDS E = 80 SECONDS
7 = 45 SECONDS F = 85 SECONDS
Spin Down/Up Time
Figure 11: Device Spin Down/Up Timer Switch