StorCase Technology DE300i-SW160 - Manual (Page 17)

StorCase Technology Inc. DE300i-SW160 User's Guide - Rev. A00
10 Installation
Installing the Receiving Frame
The drive should be installed into the carrier before installing the receiving frame into the
mounting bay of a computer or expansion chassis.
NOTE: Use a #2 Phillips screwdriver during this procedure.
1. Turn off power to the computer.
2. Open the computer system according to the manufacturer’s instructions. If
necessary, temporarily remove any expansion boards that may make
installation difficult.
3. To select the DE300i-SW160 unit ID remotely through the computer system or
external expansion chassis, the appropriate cable from the system must be
connected to option pins (1-8 on connectors J3A1, J3B1, J3C1) on the rear of
the receiving frame (Figure 8 and Table 2). Set the unit ID to "0" for remote ID
selection (Figure 10).
Figure 8: Receiving Frame Motherboard J3A1, J3B1, J3C1 Option Pin Connector