StorCase Technology DE300i-SW160 - Manual (Page 15)

StorCase Technology Inc. DE300i-SW160 User's Guide - Rev. A00
8 Installation
Figure 6: Drive Installation Assembly
Installation
1. Attach the I/O cable from the DE300i-SW160 carrier board to the drive
(Figure 6).
2. Attach the 4-pin power cable from the carrier board to the drive (Figure 6).
3. Install the 5-pin ID select cable into the carrier board connector (Figure 7).
4. Carefully insert the drive into the carrier at an angle, cable-end first. Make
sure that none of the cables are pinched. Lower the front of the
drive carefully into place. Fasten the drive into the carrier with four (4) #6-
32 x 3/16" F.H. screws provided.
5. Attach the provided drive cover with two (2) #6-32 x 3/16" F.H. screws.