StorCase Technology DE300i-SW160 - Manual (Page 21)

StorCase Technology Inc. DE300i-SW160 User's Guide - Rev. A00
14 Installation
Figure 10: Unit ID Select Switch Location
the receiving frame. Refer to Figure 11 for the location of the Device Spin Down/
Up Timer on the receiving frame. A "u" will be displayed once the drive has
completed spin down and is ready to be removed from the receiving frame. The
indicator will return to the SCSI ID number when the carrier is removed from the
receiving frame.
WARNING: Unlocking the carrier unit switches DC power off to the
drive. Since drives require a short amount of time to spin
down, allow at least 15 seconds before pulling the carrier
unit out of the receiving frame to avoid possible damage to
the drive.
3. Use the alignment tool supplied with the DE300i-SW160 to select the ID number of
the disk drive. Refer to Figure 10 for the location of the ID select switch inside the
receiving frame.
WARNING: Selecting an invalid ID number, or selecting the same unit ID
number on different devices may cause unpredictable
results and the computer system may not recognize the
installed device(s). If the computer system can not recog-
nize the boot disk, the computer system may fail to start-up
properly.
4. After selecting an appropriate unit ID number, replace the DE300i-SW160 carrier in
the receiving frame, and LOCK IT IN PLACE.
5. The new drive may need to be formatted or initialized prior to use with the
operating system and applications software. Refer to the drive and/or computer
manufacturer's documentation for formatting information.