StorCase Technology DE300i-SW160 - Manual (Page 16)

DE300i-SW160 User's Guide - Rev. A00 StorCase Technology Inc.
Installation 9
Typical 2mm Drive ID Pin Configuration
Figure 7 illustrates a typical ID select connection to a drive with 2mm ID select pins. In
most cases, the drive manufacturer labels each pair of ID select pins in their significant bit
order (0, 1, 2, 3 as shown in Figure 7). In other cases, the manufacturer does not label
these pins in their significant bit order, but instead, assigns pin numbers only. In any
case, all odd numbered pins or all even numbered pins will be the signal row. The wires
on the wire harness connect to the positive pin (or signal pins) on the drive. Refer to the
device manufacturer's documentation for additional pin numbering and jumper option
information.
Attach the ID select cable to the drive using the 2mm connectors. Align the “ID0” pin with
the black wire. Attach the other end of the ID select cable to the ID select connector
located on the carrier board, inside the carrier. Refer to the manufacturer’s
documentation to disable termination on the drive.
Figure 7: Typical ID Select Connections (2mm Drive Pins)