StorCase Technology DE300i-SW160 User Manual

Page 19

StorCase Technology Inc.

DE300i-SW160 User's Guide - Rev. A00

Installation

Mounting
Holes
(Right)

0520

Mounting
Holes
(Bottom)

Front of Unit

Figure 9: DE300i-SW160 Receiving Frame Mounting Holes

5. Adjust the front of the receiving frame so the carrier slides freely in and out on the

receiving frame guides. The position of adjoining peripheral units may require

adjustment.

6. To connect a drive to a remote activity LED in the computer system or expansion

chassis, connect the appropriate cable(s) to the receiving frame motherboard

connectors J3A1, J3B1, and J3C1 Pins 11 and 12 as shown in Figure 5.

7. Connect the I/O cable from the host adapter to the receiving frame. The Pin 1

indicator on the cable must be properly aligned. Refer to Figure 5 for the correct

Pin 1 location.

NOTE:

No onboard termination is provided on the DE300i-SW160.

External termination must be provided.

9. Connect the power cable from the DC power supply in the computer or expansion

chassis to the power connector on the DE300i-SW160 receiving frame. Refer to

Figure 5 for the DE300i-SW160 receiving frame power connector location.

4. With the drive carriers locked into place inside the receiving frame, install the

DE300i-SW160 receiving frame into the drive opening in the computer or expansion

chassis. Use the appropriate guides to position the DE300i-SW160, and fasten it

into place with eight (8) #6-32 x 1/4 screws provided. Figure 9 illustrates the

location of the mounting holes. Mounting holes are provided on each side and the

bottom of the receiving frame to accommodate a variety of mounting configurations.

Use the mounting holes which best suit the computer or expansion chassis

configuration.