StorCase Technology DE100i-S - Manual (Page 31)

StorCase Technology, Inc. DE100i-S User's Guide - Rev. H00
24 Appendix C - Optional User Configurations
Figure C-2: DAT Drive Open Front Carrier Signal Distribution Board
ID
2 (R
ed
)
ID
1 (B
row
n)
ID
0 (B
lack)
To .1" DAT
ID Select Pins
ID Select
Interface
0175
DAT Carrier
DAT Drive ID Select Cable.
Use in place of standard
1.25mm/2mm ID Select Cable.
Pin 1
J3
J6
(Reserved)
DAT Drive SCSI ID Cable Connection
The following information applies to the Data Express DE150i-CSD front-loading device carrier.
The procedure for installing a DAT drive into the open front carrier is almost identical to that
required for disk drive installation in an enclosed drive carrier.
The ID Select Cable provided for DAT drives is slightly different than the cable used for disk
drives. The DAT drive SCSI ID Select Cable uses three (3) separate connectors on the drive
end of the cable (one for each wire). Refer to the following figures for a DAT drive connection.