beautypg.com

Using the hot swap board, Jumper options, Carrier removal – StorCase Technology DE100i-S User Manual

Page 26

background image

DE100i-S User's Guide - Rev. H00

StorCase Technology, Inc.

Appendix B - Factory-Installed Options

19

Figure B-1: Attaching the Hot Swap Board

Jumper Options

The jumper pins on the Hot Swap Board are similar to those on the SCSI Data Express

motherboard. Removing the jumper at location JP1 will enable onboard receiving frame

termination (Figure B-2). Location W1 provides remote ID selection. Jumper J4 Pins 4 and 6

provide a signal to drive remote activity LED logic (Pin 4 = Anode, Pin 6 = Cathode).

Using the Hot Swap Board

Carrier Removal

Follow the procedures below to remove the DE100i-S carrier from the receiving frame

equipped with the Hot Swap option.

1. Verify that the drive is not active. If the system is on a network, make certain other

users are not accessing the target drive, then disable it from the network. Dismount

the drive.

2. Turn the DE100 key lock mechanism (located on the front of the receiving frame),

clockwise to the OFF position. This unlocks the drive from the receiving frame and

activates the Hot Swap Board. The unit ID number on the display will begin flashing.

WARNING:

Be careful not to remove or disturb the carrier unit at this point. Although

the carrier is physically unlocked, the drive requires a minimum of 15

seconds to spin down and is subject to vibration and possible damage

during this period.