beautypg.com

Receiving frame rear panel – StorCase Technology DE100i-S User Manual

Page 12

background image

DE100i-S User's Guide - Rev. H00 StorCase Technology, Inc.

Introduction

5

Receiving Frame Rear Panel

(Figure 5)

•

DC Power Connector (J3): The Data Express uses a standard 4-pin DC Power

Connector to accept DC power.

•

I/O Connector (J2): The input/output connector provides a standard interface for

all SCSI signals. See Table 2 for J2 pin assignments.

•

ID Select Pins (J4): Pins 1-14 are reserved. Pins 15-20 of this connector provide

unit SCSI ID selection for the computer system or expansion chassis. For remote

ID selection through an expansion chassis, the unit ID must be set to "0" or open (no

jumpers installed) on these pins. See Table 1 for J4 pin assignments.

•

Enable Termination Power To/From SCSI Bus (W1): The rear panel contains

the bus terminators (active) for 8-bit Single-Ended SCSI interfaces. Jumper is

installed at the factory.

•

Onboard Termination (W2): Position "A" is installed at the factory and will disable

termination. Moving the jumper to Position "B" will enable onboard termination.

Figure 4: Receiving Frame Unit ID Number and Activity Display