StorCase Technology DE100i-A - Manual (Page 18)

DE100i-A User's Guide - Rev. F01 StorCase Technology, Inc.
Installation 11
Installation
1. Attach the I/O cable on the drive carrier circuit board to the drive. Refer to Figure
8 for an illustration of the installation process.
2. Attach the 4-pin power cable on the drive carrier circuit board to the drive. If
you are installing only one drive carrier, skip to Step 4.
3. For Method 2 Users:
If you created the 3-pin Master/Slave select cable as outlined in the previous
section, install it now into the connector on the drive carrier circuit board. See
Figure 7 for a typical AT/IDE connection. Also refer to the documentation that
accompanied your drive for more specific information.
4. Carefully insert the drive into the drive carrier at an angle, cable-end first. Make
sure none of the cables are pinched. Lower the front of the drive carefully
into place. Fasten the drive into the carrier with four (4) of the eight (8) screws
provided as shown in Figure 8.
5. Install the provided cable cover.
Figure 8: Drive Installation Assembly