StorCase Technology DE90i-S - Manual (Page 18)

DE90i-S, Rev. A00 Kingston Technology Company
Installation 13
7. To connect the drive to a Remote Activity LED in the computer system or
expansion chassis, connect the appropriate cable(s) to the receiving frame
mother board as shown in Figure 3. Connect J6 Pins 4 and 6 to a remote
activity LED.
8. Connect the I/O interface cable from the host adapter to the receiving frame.
The pin 1 indicator on the cable must be properly aligned. Refer to Figure 3
for the correct pin 1 location.
Make sure that only the last SCSI device is terminated. If the Data Express is
at the end of a daisy chain, the terminators on the receiving frame must be
enabled. If the Data Express is in the middle of a daisy chain, termination
should be disabled. Refer to jumper W2 in Figure 3.
9. Connect the power cable from the DC power supply in the computer or
expansion chassis to the power connector on the Data Express receiving
frame. Refer to Figure 3 for the Data Express receiving frame power
connector location.
10. Replace any expansion boards that may have been removed earlier. Replace
the system cover according to the manufacturer’s instructions.
11. Reconnect any system or peripheral cables removed earlier.
12. Turn on power to the computer. If the installation has been successful, and
all cables have been properly attached, the system should boot normally.
Although the computer may not recognize the Data Express yet, the
appropriate front panel LED indicators on the Data Express should illuminate.
NOTE: The lock on the Data Express receiving frame functions as a lock
and a DC power switch for the carrier unit. The lock must be
engaged (turned counterclockwise) in order to supply power to the
carrier and installed drive unit.
13. The new drive may need to be formatted or initialized prior to use with the
operating system and applications software. Refer to the drive and/or computer
manufacturer's documentation for formatting information.