StorCase Technology DE90i-S - Manual (Page 15)

10 Installation
Kingston Technology Company DE90i-S, Rev. A00
The Quantum ProDrive LPS 270/540S (Figure 6) uses 1.25mm ID select pins. Connect the
1.25mm ID select cable connector to the drive ID select pins. Attach each of the 2mm
connectors on the other end of the ID select cable to the 2mm connectors (J3A) provided on
the signal distribution board, located inside the carrier. Align the “ID0” pin with the black wire
of the cable. Refer to the manufacturer’s documentation to disable termination on the drive.
0416
SCSI ID Select
Cable (from Data
Express Signal
Distribution Board)
1.25mm SCSI ID
Selection Connector J5
(located on disk drive
PCB)
SCSI I/O
Connector Power
Connector
A0
A1
A2
SCSI ID Selection Pins
JP1 (located on disk
drive PCB)
When Using J5,
Remove all
Jumpers From JP1
R
e
s
e
r
v
e
d
G
n
d
Signal Distribution Board
ID
Select
Cable
Red (ID2)
Brown (ID1)
Black (ID0)
CARRIER BOARD
Inside Carrier
1.25mm Data
Express ID Select
Interface (J3B)
2mm Data Express
ID Select Interface
(J3A)
Figure 6: Quantum 270/540S (1.25mm Drive Pins)