Star Headlight & Lantern DL15-30 - Manual (Page 12)

-9-
TD77-2 Jumper Setting for use with the DL15-30W
1. Locate the “Option” jumper location near the center of the board. (See diagram below).
(Optional TD77-2 Controller CONT’D)
To use the TD77-2 with the DL15-30W, YOU
MUST remove the jumper on the 1st pair of pins
and turn it sideways over the bottom row of the
1st and 2nd pair of pins.
TD77-2 Controller (DL15-30W Mode)
!
Move Jumper
from 1st pair
2. The first set of pins (see above) will have a jumper on them. Remove this jumper from
the first pair of pins and place it over the bottom pins of the first and second pair of pins
as pictured above.
3. Replace the cover of the TD77-2, taking care not to over tighten the screws.