Star Headlight & Lantern DL15-30 - Manual (Page 10)

-7-
Operation
SP1515-TDC or Standard Switch Operation
Important : This product is used to direct traffic. Improper use may result in
vehicular collision, personal injury and/or death. Star Headlight & Lantern Co.,
Inc., and its subsidiaries shall not be held responsible for damages directly or
indirectly caused by improper use of this product. Always carefully consider the
effect on traffic that the selected light pattern will have before engaging the lights.
PWR L C-O R
1. Operation of the DL15-30W is straightforward. Four switches are used to control the
various functions : Warn, Left, Center Out, and Right Patterns.
2. The unit is activated by switching the PWR switch ON (attached to red wire). The
light will go into Warning mode with the pattern you have pre-selected (see the
Pattern Selection section on the following page).
3. Select a Traffic Directing pattern by switching the appropriate switch ON.
L - Left Pattern
C-O - Center Out Pattern
R - Right Pattern
Please note: The PWR switch must also be on for the Traffic Directing
Patterns to activate.
4. If more than one of the Traffic Directing switches (R, C-O, L) is activated, the stick
will default to the Center-Out mode for safety reasons.
5. When using the Traffic Director, always be sure that the pattern selected is
appropriate for the present hazard condition. The potential danger in displaying
an inappropriate pattern cannot be overstated.
Once your Traffic Director is installed, please test all the patterns, options, and
alternate versions to familiarize yourself with the various patterns and the
operation of the controller.