Star Headlight & Lantern STAR-PA RSK966P - Manual (Page 6)

-3-
(Electrical Connections CONT’D)
Setting the High/Low – Head Select Jumper
The RP966 and RP996 remote strobe packs allow you to choose whether you would prefer
to have the ability to switch three pairs of heads On/Off separately OR if you would like the
ability to switch between High and Low power, switching two heads separate from the other
four heads. Prior to installation, you should decide which setting will work best for you, and
set the jumper appropriately.
LEFT POSITION
If you wish to activate three separate pairs of heads independently of each other,
leave the Head Select - High/Low Jumper in the 3-Pair Head Select position (default)
shown below. The jumper should be on the left two pins, closest to the edge of the
pack. The ENABLE wires will function as follows:
White = Enable Heads 1 & 2
Black = Enable Heads 3 & 4
Red = Enable Heads 5 & 6
RIGHT POSITION
If you would like to utilize both high and low power, or you will be activating all 6 of
your strobe heads together with one On/Off switch, or if you will be activating two
heads independently of the other four heads and do not need to operate three different
pairs of heads, the jumper should be moved to the right two pins, towards the center of
the pack. This will allow you to switch one pair of heads on one switch, the other four
heads on another switch, and select high or low power on a third switch. The ENABLE
wires will function as follows:
Black = Enable Heads 1, 2, 3, & 4
Red = Enable Heads 5, & 6
White = High/Low Option Switching