Star Headlight & Lantern SH3940 36 Strobe - Manual

PLITSTR79 REV. A 7/24/08
Model SH3940
Remote Strobe Head
Please Note: The Model SH3940 is a remote strobe head and
MUST be connected to a remote strobe power
supply. It is not designed to flash when
connected DIRECTLY to +12 VDC.
1. Your new warning light comes complete with a foam mounting gasket, two
mounting screws, two lock washers, and two rubber well nuts.
2. Remove the foam gasket from the shipping box. Each gasket comes
furnished with three holes, two outer and a center hole. (NOTE: You may have
to stretch the gasket to find the location of the three holes.) Place the gasket in
the exact position the light is to be mounted.
3. Using the gasket as a template, mark three holes on the mounting surface.
Take care to ensure that the g asket does not move while you are marking
each of the three holes.
4. Remove the gasket and drill a 3/8" hole in the two outer locations only. Drill a
1” hole in the center location for the cable, taking care to remove any burrs and
file any sharp edges that may damage the cable.
CAUTION: Take care not to drill through the headliner of the vehicle below.
5. Push the enclosed rubber well nuts through
the two outer holes in the vehicle, until the
bottom side of the wider lip rests on the
surface of the vehicle.
6. Route your cable through the center hole.
7. Place the gasket and light over the well nuts and align the holes in the flanges
with the well nuts. Insert the mounting screws and tighten until snug.
8. Connect the cable to an appropriate s trobe power supply.
If a product must be returned for any reason,
please contact our Customer Service Department to obtain a
Returned Goods Authorization number (RGA #) before you ship the product back.
Please write the RGA # clearly on the package near the mailing label.
To obtain warranty service, or if you have any questions
concerning this or any other Star product,
please contact our Customer Service Department at
(585) 226-9787.
ONE YEAR LIMITED WARRANTY
The manufacturer warrants each new product, under normal use, against factory defects in material and
workmanship for one year after the date of purchase. The owner will be responsible for returning to the Service
Center any defective item(s) with the transportation costs prepaid. The manufacturer will, without charge,
repair or replace at its option, products, or part(s), which its inspection determines to be defective. Repaired
or replacement item(s) will be returned to the purchaser with transportation costs prepaid from the service
point. A copy of the purchaser's receipt must be returned with the defective item(s) in order to qualify for the
warranty coverage.
Exclusions from this warranty include, but are not l imited to, bulbs, strobe tubes, domes, and/or the finish. This
warranty shall not apply to any light, which has been altered, such that in the manufacturer's judgment, the
performance or reliability has been affected, or if any damage has resulted from abnormal use or service. This
warranty does not apply to defect or damage occurring as a result of disaster, accident, abuse, misuse, lightning,
power surges, or failure to follow instructions in any enclosed manuals. Any damage or defects occurring as a
result of any unauthorized service or repairs by unauthorized persons shall be excluded from this warranty.
There are no warranties expressed or implied (including any warranty of merchantability or fitness), which
extend this warranty period. The loss of use of the product, loss of time, inconvenience, commercial loss or
consequential damages, including costs of any labor, are not covered. The manufacturer reserves the right to
change the design of the product without assuming any obligation to modify any product previously
manufactured.
IMPORTANT: Please read all of the following instructions before installing your new
warning light. This instruction sheet applies only to the model listed at the top of this sheet.