Roubleshooting, Lowcharts, Rocedures, and – Southbend S Series Restaurant Ranges User Manual
Page 23: Iring, Iagrams

OWNER’S MANUAL 1191904 REV 2 (5/14)
PAGE 23
OF 31
S
S
ERIES
R
ESTAURANT
R
ANGES
T
ROUBLESHOOTING
WARNING
ADJUSTMENTS AND SERVICE WORK MAY BE PERFORMED ONLY BY A QUALIFIED TECHNICIAN WHO IS
EXPERIENCED IN, AND KNOWLEDGEABLE WITH, THE OPERATION OF COMMERCIAL COOKING EQUIPMENT.
HOWEVER, TO ASSURE YOUR CONFIDENCE, CONTACT YOUR AUTHORIZED SERVICE AGENCY FOR RELIABLE
SERVICE, DEPENDABLE ADVICE OR OTHER ASSISTANCE, AND FOR GENUINE FACTORY PARTS.
NOTICE
Warranty will be void and the manufacturer is relieved of all liability if service work is performed by other than a qualified
technician, or if other than genuine Southbend replacement parts are installed.
The serial plate is located on the inside of the kick panel (see Figure 1 on page 3).
Replacement parts (including parts not listed in this manual) may be ordered either through a Southbend Authorized Parts
Distributor or a Southbend Authorized Service Agency.
When ordering parts, please supply the Model Number, Serial Number, Part Number, and Part Description.
In case of problems in operation at initial installation, check type of gas and manifold pressure and compare with
information listed on the serial plate.
This section contains troubleshooting flowcharts, procedures, and electric schematics to assist a qualified service
technician in the servicing of a Southbend S Series Restaurant Range.
T
ROUBLESHOOTING
F
LOWCHARTS,
P
ROCEDURES, AND
W
IRING
D
IAGRAMS
Find the symptom below that corresponds to the malfunction, then turn to the corresponding page. Follow the flowchart on
that page until the problem is solved.
Troubleshooting Flowchart, Procedure, or Wiring Diagram
Page
Troubleshooting Open-Top Burners
24
Troubleshooting Base Oven
25
Troubleshooting Convection-Oven Blower
26
Adjustment of Gas Pressure Regulator
27
Adjustment of Open-Top Pilots
19
Adjustment of Open-Top Burners
20
Adjustment of Oven Standing Pilot
20
Adjustment of Oven Burner
20
Calibration of Oven Thermostat
20
Adjustment of Thermostatic Griddle Bypass Flame Level
21
Calibration of Thermostatic Griddle Thermostat
21
Conversion from One Type of Gas to Another
22
Wiring Diagram for Gas Oven
29
T
ROUBLESHOOTING