SkyRC T6200 Charger - Manual (Page 6)

START
OPERATION PROGRAM
How to operate the charger?
Browse - Touch the arrow ▲ and ▼ or and to browse all the selections
Confirm – Touch your selection on the screen to for confirmation
Start – touch and hold the operation program for 3 seconds to start
the program.
Touch start button or
▲ ▲
OPERATION PROGRAM
T6200 T6200 09 08
OPERATION PROGRAM
CELLS CAPACITY
BATT TYPE
Pb
Lilon
OPERATION
DISCHARGE
VOLT METER
CHARGE
START SETTING
LiPo 6S C6.0A / D2.0A
PRESET
LiPo
mAh
P1
BATTERY CELLS
6S
CONFIRM
LiPo 6S C6.0A / D2.0A P1
BATTERY CELLS
6S
CONFIRM
LiPo 6S C6.0A / D2.0A P1
CELLS CAPACITY
BATT TYPE
Pb
Lilon
OPERATION
DISCHARGE
VOLT METER
CHARGE
START SETTING
LiPo 6S C6.0A / D2.0A
PRESET
LiPo
mAh
P1
CELLS CAPACITY
BATT TYPE
Pb
Lilon
OPERATION
DISCHARGE
VOLT METER
CHARGE
START SETTING
LiPo 6S C6.0A / D2.0A
PRESET
LiPo
mAh
P1
Touch and hold for 3 seconds
or
Touch start button
1.Connection
2).Connecting The Battery
Important!!! Before connecting a battery it is absolutely essential to check one last time that
you have set the parameters correctly. If the settings are incorrect, the battery may be
damaged, and could even burst into flames or explode. To avoid short circuits between the
banana plugs, always connect the charge leads to the charger first, and only then to the
battery. Reverse the sequence when disconnecting the pack.
3).Balance Socket
Using terminal clip
attaching to car battery
WARNING:
Failure to connect as shown in this diagram will damage this charger.
The balance wire attached to the battery must be connected to the charger with the
blackwire aligned with the negative marking. Take care to maintain correct polarity! (See
the wiring diagram below.)
This diagram shows the correct way to connect your battery to the SKYRC T6200 while
charging in the balance charge program mode only.
Here are the detailed procedures to make the charger work. All the screens and operations will
take LiPo-CHARGE program for example,
1 Connecting to Power Source ).
Please connect SKYRC T6200
supply by supplied DC input cable(XT60 connectors
attaching to charger and banana plugs attaching to power
supply).
Also you could use terminal clips with matching XT60
female connectors, for attaching directly to 12V car
batteries.
It is critically important that you use either a fully charged
13.8V car battery or a
.
charger with AC/DC power
high quality AC-DC power supply in
the range of 12V to 18V DC output, with minimum
current rating of 20A to insure reliable performance
Hold
3S”