SkyRC T6200 Charger - Manual (Page 10)

Lilon 6S C2.0A/D1.0A
BATT TYPE
Pb
LiPo
Lilon
OPERATION
CHARGE
SERVO
MOTOR
P2
CELLS CAPACITY START SETTING PRESET
mAh
Connect the battery to the power.
Connect the servo to the servo port in left side of the charger. Be careful with the correct
polarity.
Enter to Servo Tester Program in the charger, change the pulse width and check the
response of the servo. 1.
2.
3.
SERVO TESTER
Connect the servo and the charger with wire, change the pulse width value and check whether the
servo works or not.
Please do as follows,
ENTER HOME
SERVO TESTER
PULSE
PERIOD
20ms
PULSE
WIDTH
1880us
Lilon 6S C2.0A/D1.0A
BATT TYPE
Pb
LiPo
Lilon
OPERATION
SERVO
MOTOR
P2
CELLS CAPACITY START SETTING PRESET
mAh
VOLT METER
Touch start button or touch and hold “SERVO” for 3 seconds to enter servo tester.
MOTOR RPM TESTER
Users connect the sensor motor and charger with sensor wire, set the pulse width and test the
RPM of the motor. Please do as follows,
Connect the motor and ESC.
Switch off the ESC and connect it to the battery.
Connect the power to the charger.
Insert the ESC signal wire to ESC port in the charger.
Connect the motor and charger with motor sensor wire. There is a motor sensor port
beside the temp sensor.
Enter Motor RPM Tester Program, set the initial pulse width which should be the same as
the neutral position of the transmitter. We suggest to set it to 1480 as most of the
transmitters’ neutral position is like that.
Switch on the ESC.
of the motor corresponding to different pulse width. If the motor doesn’t run, please recheck
the transmitters’ neutral position and reset the initial pulse width. Touch to change the value of pulse width and check the RPM
1.
2.
3.
4.
5.
6.
7.
ENTER HOME
MOTOR RPM TESTER
PULSE
WIDTH
1480us
RPM: 14910
Touch start button or touch and hold “MOTOR” for 3 seconds to enter motor RPM tester.
/
T6200 T6200 17 16
MOTOR RPM TESTER SERVO TESTER
This diagram shows the correct connection way to test the servo.
S
E
R
V
O
E
S
C
S E
N
S
O
R
B
L M
O
TO
R
ENTER HOME
SERVO TESTER
PULSE PERIOD 20ms
PULSE
WIDTH 1880us
DC
INPUT
1
1-18V
Battery
Pack
Power Supply
This diagram shows the
correct connection way to test
motor RPM.
S
E
R
V
O
E
S
C
S E N
S O
R
B
L M
O
TO
R
Motor Sensor Wire
ESC
Switch
ENTER HOME
MOTOR RPM TESTER
PULSE
WIDTH 2100us
RPM: 14910
DC
INPUT
1
1-18V
Power
Supply
Touch to change the value of pulse width and observe the response of the servo
corresponding to different pulse width. /
Touch to change the value of pulse period depending on different servos. /