SkyRC RS16 180W/16A Balance Charger/Discharger User Manual

Page 15

BATTERY MEMORY SET

The charger can store up to 10 different charge/discharge profiles for
your convenience, and the stored profiles can be recalled quickly
without having to go through the setup process.

BATT MEMORY【1】
ENTER SET

BATT TYPE
LiPo

Enter the battery memory program, you can
change the battery type(LiPo, LiFe, LiIon, NiMH,
NiCad, Pb battery), voltage, charge current by
moving the joystick right to make the value blink,
then move the joystick up/down to alter the value,
and re-move the joystick right to store the value
and move to the next value or screen.
Note:The battery used for this example is a
2S(7.4V) Lipo battery.

DSCH CURRENT
2.2A

BATT VOLTS
7.4V(2S)

CHARGE CURRENT
4.9A

DSCH VOLTAGE
3.0V/CELL

Set the discharge current, which can be adjusted
(0.1A-8.0A).

Set the discharge voltage, which can be adjusted
(3.0-3.3V/Cell).

Set the voltage and number of cells, along with
the normal voltage (1S-6S).

Set the charge current, which can be adjusted(0.1-
16.0A).

> 3 seconds

RIGHT

UP DOWN

TVC=YOUR RISK
4.20V

SAVE PROGRAM
SAVE

SAVE PROGRAM
ENTER

BATT MEMORY【1】
LiPo 7.4V(2S)

BATT MEMORY【1】
C:4.9A D:2.2A

ENTER CHARGER
LOAD……

next flash

TEMPERATURE
CUT-OFF 50C

Set the terminal voltage, which can be
adjusted(4.18-4.30V).

Save the program set by moving the joystick
right and holding it for 3 seconds.

This screen indicate the saved profile.

This screen indicates that the charge profile is
being loaded.

Once you've saved a charge profile, you can
load those settings to use later. To load a
memory, you have to move the joystick right and
hold it for 3 seconds. Otherwise you only enter
the setting mode.

BATTERY MEMORY SET

Set the cut-off temperature, which can be
adjusted(20 C

/68 F-80 C/176 F).

UP DOWN

> 3 seconds

RIGHT

UP DOWN