SkyRC Quattro B6AC - Manual (Page 17)

NIMH/NICD BATTERY PROGRAM
These programs are for charging or discharging NiMH (Nickel-Metal-Hydride) or NiCd
(Nickel-Cadmium) battery commonly used for R/C model aplications. To alter the value at
the display, press Start/Enter key to make it blink then change the value using INC or DEC
key. The value will be stored by pressing Start/Enter key once.
To start the process, press Start/ Enter button for more than 3 seconds.
The screen displays the current state of charging.
To stop the process, press Batt type/Stop key once.
The audible sound indicates you the end of process.
NiMH CHARGE
CURRENT 2.0A
DISCHARGING OF NICD/NIMH BATTERY
NiMH DISCHARGE
0.1A CUT:1.0V
Set discharge current on the left and final voltage on the right.
The discharge current ranges from 0.1 to 2.0A and the final
voltage ranges from 0.1 to 25.0V). To start the process, press
Start /Enter key more than 3 seconds.
Battery
type
DEC
-
INC
+
The charger will charge NiCd and NiMh batteries using the charge current set by the user.
Battery
type DEC
-
INC
+
Batt type
Stop
Elapsed
time
Start
Enter
Charged
capacity
Battery
type
Charge
current
Battery
voltage
'> 3 seconds '
This program is for charging of NiCd/NiMH batteries. You can
press Start/Enter key to make it blink and then Inc or Dec to
change the parameter value. Press START/ENTER key to store
the value.
Discharge
current
The screen indicates the discharging state. You can press
Start/Enter key to alter discharge current. Press Start/Enter
again to store the value. Press Batt Type/Stop key to stop
discharging. The emitted sound alerts the end of discharging.
Battery
type
Battery
voltage Elapsed
time
Discharged
capacity
Batt type
Stop Start
Enter
'> 3 seconds '
NiMH 0.1A 7.42V
DSC 022:45 00890
CHARGING NICD/NIMH BATTERY IN THE AUTO CHARGE MODE
In this program the charger detects the condition of the battery which is connected to the
output and automatically charges the battery. In this mode, you should set up the upper
limit of the charge current to avoid damage by excessive feeding current. Some batteries of
low resistance and capacity can lead to higher current in the auto charging mode.
This program is for charging of NiCd/NiMH batteries. You can
press the Start/Enter button to make it blink and then press the
Dec/Inc button to change the parameter value. Press the
Start/Enter button more than 3 seconds to start the charging
process.
N i M H A u t o C H A R G E
C U R R E N T 2 . 0 A
N i M H 2 . 0 A 9 . 5 2 V
A U T 0 0 0 : 1 3 0 0 0 0 0
ENTER
/START
CHARGING OF NICD/NIMH BATTERY