SkyRC Quattro B6AC - Manual (Page 16)

PB( LEAD-SULPHURIC ACID) BATTERY PROGRAM
This is programmed for charging Pb(lead-sulphuric acid) battery with nominal voltage from
2 to 20V. Pb batteries are totally different from NiCd or NiMH batteries. They can only
deliver relatievely lower current compare to their capacity, and similar restrictions definitely
apply to charge. So the optimal charge current will be 1/10 of the capacity. Pb batteries
must not be charged rapidly. Always follow the instruction is supplied by the manufacturer
of battery.
When you are willing to alter the parameter value in the program, press Start/Enter key to
make it blink then change the value with INC or DEC key. The value will be stored by
pressing Start/Enter key once.
DISCHARGING OF PB BATTERY
Battery
type
DEC
-
Batt type
Stop
Elapsed
time
INC
+
Charge
current
Battery
voltage
DEC
Start
Enter
-
INC
+
Charged
capacity
'> 3 seconds '
DEC
-
Batt type
Stop
INC
+
DEC
Start
Enter
-
INC
+
Battery
type Elapsed
time
Discharge
current
Battery
voltage
Discharged
capacity
'> 3 seconds '
Set up the charge current on the left and the nominal voltage of
the battery on the right. The charge current ranges from 0.1 to
6.0A and the voltage should be matched with the battery being
charged.
Start the charge process by pressing Start/Enter key for more
than 3 seconds.
The screen displays the state of charging process. To stop
charging forcibly, press Batt type/Stop key once.
The audible sound indicates you at the end of process.
Set discharge current on the left and final voltage on the right.
The discharge current ranges from 0.1 to 2.0A.
To start the process, press Start/Enter key for more than 3
seconds.
The screen displays the current state of discharge. You can alter
the discharge current by pressing Start/Enter key during the
process. Once you change the current value, store it by pressing
Start/Enter button again.
To stop discharging press Batt Type/Stop key once. The audible
sound indicates you at the end of process.
CHARGING OF PB BATTERY