SkyRC Quattro B6AC - Manual (Page 14)

LITHIUM BATTERY(LIPO/LILO/LIFE)PROGRAM
INC INC DEC DEC
- -
+ +
Start
Enter Batt type
Stop
Start
Enter
Charged
capacity
Number
of
cells
Charging
time
Charging
current
Battery
voltage
The left side of the first line shows the type of battery you choose.
The value on the left of the second line of the charger is current
user set. After setting the current and voltage, press Start/Enter
key for more than 3 seconds to start the process.(charge current:
0.1-6.0A, voltage: 1S-6S).
This displays the number of cells you set up and the processor
detects. R shows the number of cells detected by the charger and
S is the number of cells set by you at the previous screen. If both
numbers are identical you can start charging by press Start/Enter
button. If not, press Batt Type/Stop button to go back to previous
screen to carefully check the number of cells of the battery pack
before going ahead.
This screen shows the real-time status during charge process.
Press Batt Type/Stop key once to stop the charge process.
'> 3 seconds '
‘FAST' CHARGING OF LITHIUM BATTERY
The charging current is getting smaller as the process goes to the near end term of Lithium
battery charging. To finish charging process earlier, this program eliminate certain term of
CV process. Actually, the charging current will goes to 1/5 from the initial value to end the
process while the normal charging goes to 1/10 during CV term. The charging capacity
may be a bit smaller than normal charging but the process time will be reduced.
INC INC DEC DEC
- - + +
The value on the left side of the second lines sets the charge
current. The value on the right side of the second lines sets the
battery pack's voltage. After setting current and voltage, press
Star/Enter for more than 3 seconds to start the process.
Start
Enter Batt type
Stop
'> 3 seconds '
Start
Enter
This displays the number of cells you set up and the processor
detects. R shows the number of cells detected by the charger
and S is the number of cells set by you at the previous screen. If
both numbers are identical you can start charging by press
Start/Enter button. If not, press Batt Type/Stop button to go back
to previous screen to carefully check the number of cells of the
battery pack before going ahead.
Current
voltage
battery Supplied
capacity
Charge
current
Charging
time
Number
of
cells
This screen shows the real-time status during charge process.
Press Batt Type/Stop key once to stop the charge process.