Denon DRA-F101 - Manual (Page 6)

6
ENGLISH
SPEAKER SYSTEM
SYSTEM
CONNECTOR
PRE
OUT
SUB
WOOFER REC PB
MD TAPE INPUTS
REC PB DVD/AUX CD PHONO
1 AM LOOP ANT.
ANTENNA
2 L
+
-
R
SPEAKER IMPEDANCE 4~16
FM COAX.
75
L
R
R L R L R L L R
L R L R R L
R
L
R
L
R
L
R
L
DVD
B
R
L
(L)
Subwoofer
(R)
4 CONNECTIONS
2 When connecting, also refer to the manuals of the other components.
2 When connecting to the DCD-F101, make the system connection shown by dotted line on the diagram below.
2 The DRA-F101 is not equipped with connection cord. Use the connection cord included with the DCD-F101.
NOTE:
• To allow for heat dispersal, do
not place another component
or any other object directly on
top of the DRA-F101.
NOTE:
• If noise is generated
when the ground wire is
connected, disconnect
the ground wire.
• When making system connection with the DCD-F101, connect the
system cord to the DRA-F101 system connector (either 1 or 2).
(System connection is indicated by dotted line on the diagram.)
• The D-F101 series stereo
receiver (DRA-F101) is
equipped with a clock and timer
function, so be sure to connect
it to a wall power outlet to
which power is supplied
constantly.
Speaker system
MD recorder
Cassette deck
CD player (DCD-F101)
NOTES:
• Do not plug the power cords into the power outlets until all connections have been completed.
• Check the left and right channels and be sure to interconnect them correctly (R to R, L to L).
• Plug in the power cords securely. Incomplete connections will result in noise.
• Use the AC OUTLET for audio equipment only. Do not use them for hair driers, etc.
• Do not clasp the connection cords together with the power cords or place them near other electric products. Doing so may
result in noise.
• The PHONO input jack is extremely sensitive. A booming sound may be produced from the speakers if the volume is turned
up when no turntable is connected.
• The sound of another component may be heard if no component is connected to the input jacks of the function selected
with the FUNCTION selector.
DVD player
Power plug
AC 120V, 60 Hz
(Plug into a power outlet)
Turntable
(with MM cartridge)
NOTE:
• This unit cannot be used with MC cartridges directly. Use a head
amplifier or a step-up transformer with MC cartridges.