Denon DRA-F101 - Manual (Page 14)

14
ENGLISH
(2) Presetting AM and FM stations
Example: To preset the currently tuned in FM station at preset number “3”
Procedure
1
Press the MEMORY/SET button.
• The
“P.SET”, “MEMO”
indicator flashes.
• Depending on what preset number is
displayed before the button is pressed, the
preset number section flashes as shown
below and the setting standby mode is set.
When “01” to “10” or “0-” is displayed,
“0-” flashes.
When “11” to “20” or “1-” is displayed,
“1-” flashes.
When “21” to “30” or “2-” is displayed,
“2-” flashes.
When “31” to “40” or “3-” is displayed,
“3-” flashes.
✽ To store the station at a different preset
number, use the tuning buttons (TUNING UP
or DOWN) to set the desired preset number.
2
Press the MEMORY/SET button
again while the “MEMO”
indicator is flashing.
• The “MEMO” indicator turns
off and the station is preset.
3
✽ A total of 40 AM and FM stations can be preset
using this procedure.
Presetting
• When a station is preset, both the reception
frequency and reception mode are stored in the
memory.
• If a station is preset at a number where another
station is already preset, the previous station is
erased and the new station is set.
• The preset memory is not erased immediately if the
power supply is cut off momentarily.
• This setting can also be made by pressing the
button instead of pressing “e”.
• To store the station at a different preset number,
use the number buttons and the +10 button on the
system remote control unit (RC-927) to set the
desired preset number.
Examples:
To store the station at preset number 12:
Press ,
To store the station at preset number 29:
Press , , 9 +10 +10
2 +10
TUNING
PHONES
SYSTEM
VOLUME
ON / STANDBY
AM-FM STEREO RECEIVER DRA-F101
SOURCE DIRECT BAND UP DOWN TUNING MEMORY / SET FUNCTION TIMER TONE DISPLAY
1, 3 2
UP DOWN
TUNING
MEMORY
/ SET
MEMORY
/ SET
MEMORY
/ SET
MEMORY
/ SET 3
/ /
DRA-F101
(this unit)
DRA-F101
(this unit)
(RC-927)
✽ When operating with the
system remote control unit,
first set the remote control
unit’s function selector switch
to “TUNER”.
TUNER
CD
MD
TAPE
(RC-927)
(3) Tuning in Preset Stations
Example: To tune in the station stored at preset
number “3”
✽ When operating with the
system remote control unit,
first set the remote control
unit’s function selector switch
to “TUNER”.
TUNER
CD
MD
TAPE
(RC-927)
Procedure:
• Instead of pressing e, the preset
channel can also be called out by
pressing the < or > button to display
“P.SET 03”.
• To call the station at a different preset number, use
the number buttons and the +10 button on the
system remote control unit (RC-927) to set the
desired preset number.
Examples:
To call the station at preset number 12:
Press ,
To call the station at preset number 29:
Press , , 9 +10 +10
2 +10
3
While the “MEMO” indicator
is flashing, press the TUNING
UP button three times to
display “P.SET”, “03”.