Simaudio Neo 350P Preamplifier - Manual (Page 15)

350P Preamplifier
____________________________________________________________________________________
15
Remote Control Operation
The Nēo 350P Preamplifier uses the ‘CRM-2’ full-function remote control
(figure 3). It operates on the Philips RC-5 communication protocol and is can
be used with other Simaudio MOON components.
The ‘CRM-2’ remote uses two AA batteries (included). To install them,
simply slide the back plate off in the direction of the arrow; insert the
batteries in the correct direction and then replace the back plate.
To engage the ‘CRM-2’ remote for use with the Nēo 350P Preamplifier, you
must first press the button labeled AMP.
The POWER button located on the upper left will switch the Preamplifier to
either ‘Standby’ or ‘On’ mode.
The DISPLAY button turns the front panel display on and off
The 2 buttons labeled ◄ INPUT ► allow you to sequentially scroll, either
backwards or forwards, through all available inputs. For example, to switch
from the “A3” to the “CD” input, press ◄ INPUT three (3) times. To switch
from the “CD” to the “A3” input, press INPUT ► three (3) times. Pressing
and holding down either of these buttons results in only a single change to
the selected input.
The 2 buttons labeled ▼ VOL ▲ allow you to control the volume level.
Pressing ▼ VOL results in a decrease in the volume level; Pressing VOL ▲
results in an increase in the volume level. You may either press and hold
these buttons down or press them briefly to make volume adjustments.
The MUTE button turns off the output volume. Pressing the “Mute” button a
second time will reinstate the output volume level back to its current setting.
NOTE: The buttons labelled ◄ BAL ► don’t affect the operation of the 350P.
Figure 5: CRM-2
Remote Control