Simaudio Neo 350P Preamplifier - Manual (Page 14)

350P Preamplifier
____________________________________________________________________________________
14
Operating the 350P
We recommend leaving your Nēo 350P powered up
at all times to maintain optimal performance. When
you plan on being away for a few days, it may not
be a bad idea to power off your preamplifier. Please
keep in mind that once fully “broken-in”, your 350P
requires several hours of operation before reaching
optimal performance after powering it up again.
Turning on your Nēo 350P for the first time
Prior to turning the preamplifier on for the first time,
make sure that every cable is properly connected to
avoid any problems. Flick the main rocker switch,
located on the rear panel, labeled “POWER” to the
‘1’ (on) position to place your 350P in to standby
mode. Next, briefly press the push button labeled
“Standby” located on the front panel. You will hear a
very faint click sound confirming that everything is in
order. The blue LED on the front panel will
illuminate, indicating that the 350P is now powered
up and ready for use.
On and Off Sequence
To avoid having any annoying noises (ie. “thumps”
and “pops”) emanate from your speakers when
powering your 350P on or off, you should always
power up your 350P prior to powering up your
amplifier. As well, always power down your 350P
after powering down your amplifier(s).