Rocktron Patchmate Loop 8 Floor - Manual (Page 22)

22
PRESETS - Selecting, Creating & Storing:
To create and store a preset follow these instructions ;
To select a preset :
1 Press and Release the "STORE" Switch. The LED next to the word "PRESET" will light.
2 Press the desired PRESET number using the switches on the top panel. Switch Number 1 is
preset number 1 and so on.
3 After the preset has been selected the PatchMate LOOP 8 Floor will revert to "LOOP" Mode.
You will now be able to turn ON/OFF LOOPS within this preset.
To Create and Store a preset:
1 First you must determine which preset number you would like to create and then select that
number by pressing the corresponding switch. The preset number must be the first switch you select in
this process.
2 Turn ON or OFF the desired LOOPS (including the loop corresponding to the switch you have
selected for the preset).
3 Press and HOLD the STORE switch down until the LED lights and then goes out.
You have now saved the preset.
Here is an example:
Lets set up SWITCH 1 (PRESET 1). In this preset we want LOOPs 2, 4 and 8 to be on all others off.
Thus the process is as follows:
1 Press and Release the "STORE" Switch. The LED next to the word "PRESET" will light.
2 Press switch 1 (this selects the preset number)
3 Press "ON" Loops 2, 4 and 8 by pressing switches 2, 4, and 8. The corresponding LEDs will be
"ON" or lit.
4 Turn "OFF" LOOPs 1, 3, 5, 6, and 7 by pressing switches 1, 3, 5, 6, and 7 if necessary. The
corresponding LEDS will be "OFF."
5 Press and HOLD the STORE switch until the RED LED lights (turns "ON") and continue to
hold until the LED turns "OFF." The preset now has been stored and the PatchMate LOOP 8 Floor has
reverted to "LOOP" Mode
So, lets test this to confirm. Turn "ON" all LOOPs. Now PRESS and RELEASE the STORE switch
quickly to access "PRESET" Mode. Press switch 1. If stored correctly LOOPS 2, 4 and 8 will be "ON"
and all other loops "OFF" indicated by the LEDs above switches 2, 4 and 8 being on and all other LEDs
off.