Specifications – Rocktron Patchmate Loop 8 Floor User Manual

Page 2

Your PatchMate LOOP 8 Floor has been designed to comply with the following Standards and Directives as set forth

by the European Union:

Council Directive(s): 89/336/EEC, 73/23/EEC, 76/769/EC, 1994/62/EC, 2000/

53/EC, 2002/95/EC

Standard(s):

EN55022, EN50082-1, EN60065

This means that this product has been designed to meet stringent guidelines on how much RF energy it can emit,

and that it should be immune from other sources of interference when properly used. Improper use of this equipment

could result in increased RF emissions, which may or may not interfere with other electronic products.

To insure against this possibility, always use good shielded cables for all audio input and output connections. This will

help insure compliance with the Directive(s).

Active Input Impedance

Active Output Impedance

Input Jacks

Send Jacks

Return Jacks

Output Jacks

Power requirements

Dimensions

MIDI In/Thru/Out

Phantom power

Presets

MIDI program change

Midi control

Relays

1.5M ohms

150 ohms

1/4” mono

9VAC 2 amps 4 pin DIN connector

19” wide, 3” tall, 4.5" deep

483mm x 75mm x 114mm

7 pin DIN, (standard 5 pin cable plugs in without phantom power feature)

Thru/Out 5 pin DIN

Provided on MIDI IN jack pins 6 and 7 - 9VAC 2 amps

128

0-127

Change commands in groups of 8 with 16 banks 0-7, 8-15, 16-

23.................120-127

Gas filled, contacts gold plated

SPECIFICATIONS