Pitney Bowes DI380 OfficeRight Systems - Manual (Page 11)

Introduction • 1
1-5 SV61789 Rev. A
Machine Identification
Sheet Feeder 1 — This feeder is intended for feeding material
that requires folding.
In addition, you can set sheet feeder 1 to
Manual Feed. In this
mode, you can run stapled sets of up to five sheets. The ma-
chine waits for you to feed each set by hand into sheet feeder
1 before folding and inserting the set automatically. See the
Specfcatons section of this guide for full details of the sets
possible.
Sheet Feeder 2 — For feeding material that requires folding.
Its functions are similar to those of sheet feeder 1, but the
manual feed option is NOT available from this feeder.
1
2
1
5
3 6
4
7
2
8
9
10
11
12