Pitney Bowes B700 - Manual (Page 14)

13 SV60943 Rev. B
6. Install the Stacker
Slide the stacker up against the right side of
the meter and position it as shown. The stack-
er sits next to the meter. It’s not physically
connected to it. In this position, the stacker
can handle envelopes up to #10. If you’re us-
ing longer envelopes, move the stacker to the
right to accommodate them.
7. Make a Test Imprint
Follow the steps below to make a test imprint.
a. The display normally shows the default
postage amount shown at the right. This
is usually the rate for first class letter mail
weighing up to one ounce.
b. At the keyboard type a 0 (zero) and then
Enter.
c. The display now shows zero as the post-
age value. The meter is ready to use
when the amount you entered is brack-
eted by three bars as shown.
d. Place a sample envelope on the feed
deck face up and push it against the rear
wall of the meter (1).
e. Slide the envelope to the right (2) until its
lead edge touches the trip mark on the
feed deck.
f. The meter will sense the presence of the
envelope, convey it through the print area
and into the stacker. The meter impres-
sion should look similar—but not neces-
sarily identical—to that shown in the figure
at right.
Default Postage Amount
Zero Postage Value
Push envelope up to
mark on deck
1
2
B700/B702 Quick Install Guide
SV60943B Book.indb 13 SV60943B Book.indb 13 5/20/2004 2:31:21 PM 5/20/2004 2:31:21 PM