Parr Instrument A2110E - Manual (Page 6)

Motor Controller
P a r r I n s t r u m e n t C o m p a n y 6
Installation
General Instructions
Set the controller near the reactor on a sturdy bench
or table where there is convenient access to an
electrical outlet capable of carrying the appropri-
ate current. Leave a space of at least twelve inches
between the controller and the reactor so that the
controller will not be affected by radiant heat.
Motor:
Secure a clamp on motor cord to
controller with provided screw next to
motor socket for safety purposes.
The motor output connector is to be used only with
Parr Instrument Company motor assemblies sup-
plied with the appropriate motor power cord.
Other appropriate connectors are provided on the
rear panel of the controller.
The RPM Input connection is for the RPM Module
sensor input.
The Comm connector is for Communication output.
Rear View A2110E Motor Controller (230V shown)