Installing optional tail skid, Installing tail – ParkZone PKZ5980 User Manual
Page 9
EN
1. Place a piece of supplied double-sided tape (A) on the horizontal tail as
shown, then install the horizontal tail on the fuselage.
Tip: A drop of CA (cyanoacrylate adhesive) can be used instead of tape. Only
use a small amount to allow for removal of the horizontal stabilizer.
2. Turn the rudder to the right or left and secure the horizontal tail to the
fuselage using a screw (B).
3. Connect the linkage clevis to the outermost hole on the elevator
control horn. Where needed, disassemble in reverse order.
Installing Optional Tail Skid
A
1
3
2.5 X 8mm (1)
B
2
Installing Tail
As desired, install the non-steerable skid for grass runways and
scale appearance.
Installing the Tail Skid
1. Install the skid plate (A) on the fuselage using 4 screws (B).
1.5 X 8mm (4)
B
A
9