ParkZone PKZ5980 - Manual (Page 8)

EN
1. Rest the aircraft on its landing gear.
2. Install the left and right cabanes (A) over the respective L-brackets (B) on
the upper wing. Turn the cabanes on the brackets so the cabanes face in
as shown.
3. Hold the cabanes and turn the upper wing over the fuselage to connect the
aileron connectors to the Y-harness connectors (C) in front of the cockpit.
The left and right aileron servos can be connected to either side of
the Y-harness.
4. Attach the cabanes to the fuselage using the included 4 screws (D).
TIP: Spread apart both wings a small amount when installing the left and right
interplane struts in the lower wing.
5. Insert the L-brackets of the left and right interplane struts (E) in the slots in
the lower wing as shown.
6. Align the tops of each interplane strut with mounts in the upper wing and
install a retainer pin (F) through the aligned holes. Secure the loop of each
pin around a front strut.
When needed, disassemble in reverse order.
Installing Upper Wing
2
3
A
B
C
4
6 5
3 X 10mm (4)
D
E F
8