Installing landing gear – ParkZone PKZ5980 User Manual

Page 7

Assembling Landing Gear

1. Install the left and right (marked L and R) landing

gear covers (A) on the axle assembly (B) using
left and right simulated shock absorbers (C)
(marked L and R) and 4 screws (D).

2. Install a spacer (F) and wheel (G) on each end of

the axle using a wheel collar (H) and
setscrew (I).

Tip: Use a small amount of threadlock on the screw
of the wheel collar to ensure the wheel is secured
to the axle.

Attaching Landing Gear

1. Turn the fuselage so that the bottom of the wing

faces up.

2. Carefully install the front, then the rear of the

assembled landing gear (J) in the fuselage slots.
It takes a small amount of force to spread the
landing gear enough to insert it into the fuselage
slots.

3. Install the left and right, back and front (marked

LB, RB, LF and LB) plates (K) over the fuselage
slots using 8 screws (L).

4. Where needed, disassemble in reverse order,

carefully spread the landing gear wires to
remove the assembly from the fuselage.

2.5 X 8mm

(8)

3 X 4mm

(2)

1.5 X 6mm

(4)

Installing Landing Gear

This manual is related to the following products:

PKZ5975