ParkZone PKZ5980 - Manual (Page 6)

EN
1. Turn the aircraft and lower wing over so the bottom
side faces up.
2. Install the wing’s mounting plate in the fuselage.
3. Align and attach the wing to the fuselage using 2
screws.
When needed, disassemble in reverse order.
1 2 3
• Lower throttle and
throttle trim to
lowest settings.
• Connect battery
to ESC.
Continuous LED
Series of tones
Power on
Transmitter
Wait 5
seconds
3 X 10mm (2)
Before Flight
Installing Lower Wing
6
Installing a Receiver
Battery Selection and Installation
1. Before installing the wing, install your park fl yer or full range receiver in the
fuselage using hook and loop tape or double-sided servo tape.
2. Attach the elevator and rudder servo connectors to the appropriate chan-
nels of the receiver.
3. Attach the aileron Y-harness to the aileron channel of the receiver.
4. Attach the ESC connector to the throttle channel of the receiver.
1. We recommend the ParkZone 1800mAh 11.1V 3S Li-Po battery (PKZ1031).
2. If using another battery, the battery must be at least a 1800mAh battery. 3. Your battery should be approximately the same capacity, dimensions and
weight as the ParkZone Li-Po battery to fi t in the fuselage without changing
the center of gravity a large amount.