ParkZone PKZ5980 - Manual (Page 10)

EN
As desired, install the steerable tail wheel for hard fi nished runways.
Installing the Tail Wheel
1. Remove the 2 screws (A) from the rudder control horn (B) and turn the
rudder to the left. Turn the control horn on the clevis for more space
and to expose the rudder box (C) as shown.
NOTICE: Do NOT remove the back plate from the other side of the rudder
or the decal and paint will be damaged.
2. Cut a channel (D) in the fuselage foam for the tail wheel wire.
3. Turn, then push up the wheel wire (E) through the L-shaped channel in
the horizontal stabilizer to the rudder box on the right side of the
rudder. Align the wheel wire in the channels (F) lower in
the fuselage.
4. Turn the wheel wire (G) so the hook on the wire goes over the block
in the rudder box (C).
5. Install the rudder horn over the rudder box using 2 control horn screws.
6. Cover the wire using the wheel plate (H) and 4 screws (I).
Disassemble in reverse order.
Installing Optional Tail wheel
1
2
3
A
B
C
D
4 G
E
F
5
6
H
I
C
10