ParkZone PKZ3980 - Manual (Page 7)

12 13
Once the Li-Po battery has been fully charged, it’s ready to be
installed in the airplane.
Install the battery in the airplane by placing it into the slot on the
bottom of the fuselage with the plug facing toward the front of
the airplane.
Note: If you are using E-flite mCX batteries or other batteries
without hook and loop tape, we have included extra
hook and loop tape pieces to allow you to use these
batteries.
Installing the Flight Battery First Flight Preparation
Please note this checklist is not intended to be a replacement
for the content included in this manual. Although it can be used
as a quick start guide, we strongly suggest reading through this
manual completely before proceeding.
• Remove and inspect contents
• Install landing gear into the plastic landing gear mounts on
the bottom of the wing
• Install 4 AA batteries into the battery charger
• Begin charging the flight battery
• Install batteries in the transmitter (as required)
• Test the controls
• Familiarize yourself with the controls
• Find a suitable area for flying
• Always turn on the transmitter first
• Plug the flight battery into the lead from the receiver
• Allow the receiver to initialize and arm properly
• Fly the model
• Land the model
• Unplug the flight battery from the receiver
• Always turn off the transmitter last
Flying Checklist