Mossberg International SA-2 - Manual (Page 23)

23
FUNCTION TESTING
After performing any work on your firearm such as cleaning, disassembly,
or installation of any accessory, check your firearm for proper functioning
before firing any live ammunition.
Be sure the firearm is completely unloaded by visually and physically
checking the chamber, elevator, and magazine tube. Also make certain
the firearm is pointed in a safe direction at all times.
1. Move the safety button fully to the right to the “ON” (SAFE) position.
2. Grasp the operating handle and pull the bolt fully rearward. It should lock in
the open position.
3. With fingers and other objects clear of the ejection port, press the bolt release
and allow the bolt to move forward under spring pressure. It should lock in the
fully closed position. Repeat this procedure several times to check for free
movement of the action assemblies.
4. With the action closed and the safety button fully to the right in the “ON”
(SAFE) position, pull the trigger fully rearward. The hammer should not fall
(NO FIRE).
5. Remove your finger from the trigger. Move the safety button to the left to the
“OFF” (FIRE) position. The hammer should not fall (NO FIRE).
6. Leave the safety button in the “OFF” (FIRE) position.
7. Pull the trigger rearward. The hammer should fall (FIRE).
8. Open the action. Move the safety button to the right to the “ON” (SAFE) position.
IF YOUR FIREARM DOES NOT PERFORM AS DESCRIBED IN ANY OF
THE ABOVE STEPS, CONTACT THE FACTORY AUTHORIZED PRODUCT
SERVICE CENTER IMMEDIATELY. DO NOT ATTEMPT TO USE THE
FIREARM.
67425 6/2/09 10:56 AM Page 23