Mossberg International SA-2 - Manual (Page 20)

20
STOCK SPACER SYSTEM
Included with this shotgun is a matching set of stock spacers. These spacers allow
you to raise or lower the vertical position of the stock. Each spacer is marked with
the amount of drop or rise they will provide.
Stock Spacer Installation (Figure 18)
Move the safety button so it is fully protruding out of the right side of the
trigger guard and cannot be moved any further indicating the “ON” (SAFE)
position. Pull back the operating handle. The action should stay opened.
Visually and physically check the chamber, elevator, and magazine tube to be
certain the shotgun is unloaded. Wear eye protection during disassembly.
1. Remove recoil pad (screws will remain in recoil pad).
2. Remove stock bolt using 1/2" socket wrench (Rotate counterclockwise).
3. Remove stock.
4. Place selected stock spacer on back of receiver, text side facing out.
(Note clocking slot).
5. Reinstall stock.
6. Install stock bolt. Do not over-tighten.
7. Replace recoil pad. Do not over-tighten screw.
After performing any work on your firearm such as cleaning, disassembly,
or installation of any accessory, check your firearm for proper functioning
before firing any live ammunition.
Figure 18
67425 6/2/09 10:56 AM Page 20