MOCET IP3021A - Manual (Page 18)

Page 18
MOCET IP3022 SOHO IP Deskphone User Guide
2
Headset
Connector
RJ-9 Jack for connecting headset cord.
3 LAN Port
RJ-45 Jack 100/10Mbps Ethernet port for connecting to the
local area network (LAN). This port can support power over
Ethernet (PoE) if the LAN switch provides it.
4 PC Port
RJ-45 Jack 100/10Mbps Ethernet port for connecting to a
computer.
5 Power DC Jack
If a power source from adaptor is required, the adapter is
plugged in here. Please order the IP3022 power adapter
separately from MOCET.
6 EDM Port
SATA interface for attaching the Extended Dial Module (IP-
EDM) accessory. Up to two IP-EDMX units can be
supported on the IP3022. Please refer to IP-EDMX Quick
Installation Guide for more information.
[Note]: If you are using a power adaptor 5V/550mA, you
should change to a 5V/2A power adaptor which is one
standard power supply of IP3000 phone series.
7
Console /
EHS Port
This port has two functions. The default function is EHS
(Electrical Hook Switch) interface, and the port can be
configured via phone Menu settings.
1. Console port: it is for engineering maintaince purpose.
2. EHS port: it connects to IP-EHS for Wireless Headset
support. This can be connected to a general DHSG, or
Jabra UART or Plantronics APD-80 interface.
8 Stand Slots These 2 slots are used for snapping the stand.
9 Hang Holes These 2 holes are reserved for wall-mount support.
10
Wire Route
Ditch
The wires of Handset and Headset can be routed and run in
the ditches.
Their locations are shown in the figure below.