MOCET IP3092 - Manual (Page 10)

Page 10
MOCET IP3092/IP3092L Communicator User Guide
Then plug in the other end of power adaptor to the wall power AC power outlet. Then you
will see LEDs on the Communicator light up and after about two minutes the
Communicator will be ready to use..
1.3.4. Starting Up:
The Communicator will take about two minutes to start up. Please don’t insert the iPad into
the Communicator until the the blue message waiting indicator (MWI) LED turns off.
1.3.5. Inserting The iPad:
Befroe you inserting your iPad, please make sure your iPad is met with the model of
Communicator as shown in below:
IP3092 is for iPad 1, iPad 2 and new iPad (3
rd
Generation) by using 30-pin connector
IP3092L is for iPad 4 by using 8-pin lightning connector
For the iPad 2, iPad 3 and iPad4, keep the add-on tray in the Communicator. To use an
iPad 1 in the Communicator, please remove the add-on tray first. (see figure below).
After that, simply by sliding your iPad into the front bezel slot and pushing it into the
Apple 30-pin connector (IP3092) or 8-pin lightning connector (IP3092L) in the
Communicator, the battery signal showed on the upper right cornor of iPad screen
changed from to and the Apple iPad will show message “ IP Commander
would like to communicate with the Mocet IP3092, Ignore or Allow” letting you know
that the Communicator is ready to go.