Mighty Mule FM702 - Manual (Page 33)

29
2. Set the transmitter DIP Switches
There are nine (9) transmitter DIP switches; each can be placed in one of three different
positions (+, 0, –). DO NOT set all the switches in the same position, such as all +, all 0, or
all –. Once the DIP switches have been set to a personal code, replace and close the access
cover.
WARNING: No other adjustments should be made inside the transmitter.
3. “Teach” the New Code to
Control Board Memory
A. Turn control box power switch OFF.
B. Unscrew and remove the control box cover.
C. Press and hold the LEARN button on the control board,
and turn the power switch ON. Release LEARN button.
Wait 15 seconds for the receiver to charge.
D. Press and hold transmitter button until the red STATUS
LED comes ON.
E. Release transmitter button. The new code is stored in
control board memory.
1234 ON
RCVR
SEQ1
SEQ2
LEARN
STATUS
R B G
AUTOCLOSE
INERTIA
OBSTRUCT
SENS.
PULL/PUSH
SNGL/DUAL MIN MAX
MIN
OFF 120
60
MAX
STATUS LED
Setting Your Personal Transmitter
Code
1. Remove the Transmitter
Cover
Grasp the sides of the access cover and slide it away from the transmitter
button (see illustration). When the access cover is removed, the battery
and the DIP switches will be exposed. To set a new code, use a small
screwdriver to move the switches.
, Inc. , Inc. , Inc.
All GTO transmitters are set to a standard code at the factory and are ready to operate your Mighty Mule Gate Opener ® .
For your safety and security, however, we strongly recommend that you replace the factory setting with your own personal
code. Follow the directions below: