Luxul XAP-1230 - Manual (Page 13)

13
User Guide
© 2014 Luxul. All Rights Reserved.
Other trademarks and registered trademarks are the property of their respective owners
„
IP Address. This field shows the IP Address that is assigned to the XAP-1230. To ensure
plug and play capability with other Luxul networking products, the IP Address is set to
192.168.0.10. If desired, the user can set this to a different static IP Address. To change
the IP address of the Access Point, simply type in the desired IP Address (the text field
will be red if the address is not valid), click Apply and then Reboot for the changed
to take effect. When connecting to the Access Point through the web interface, the
NEW IP Address must be used.
NOTE: Each device on the same network must have a unique IP address.
If the Access Point is assigned an IP Address already in use, it will
result in an IP Address conflict that must be resolved manually. For
optimal communications with all Luxul devices on the network, it is
recommended that IP Addresses not be changed unless necessary.
„
Subnet Mask: To ensure plug and play capability with other Luxul networking prod-
ucts, the Subnet Mask is set to 255.255.255.0. Although not recommended, the user
can set this to a different static Subnet Mask.
„
Default Gateway: A Gateway is a router on the network that connects two or more
networks together. Typically the Gateway (router) connects the local area network
(LAN) to the Internet (WAN). The Internet Service Provider (ISP) often provides
a physical device (usually a DSL modem or cable modem) that connects to the
Gateway with an Ethernet cable, thus completing the link to the Internet.
The Default Gateway field is the IP Address for this routing device. The Access Point
uses the Gateway IP Address to set time for the system log files. Although not required,
it is recommended you enter the gateway IP address information.
„
Operating Mode: Sets the operation type of the AP. Supported modes include:
w
Access Point (provides access to client devices)
„
Network Name (SSID): Sets the name of the Wireless Network. The default name is
Luxul1230. It is recommended to change the SSID from the default name. The SSID is
case sensitive and can contain:
w
2 – 32 alphanumeric characters
w
Spaces (Although Spaces are allowed, some client devices may have trouble con-
necting, it is recommend Spaces and Special Characters are not used)
w
Special characters (i.e. @#$%&*)
To change the SSID of the wireless network, simply type the desired name, click Save,
and then Reboot for the change to take effect.